What saddle hooklets are
Saddle hooklets hold the edge of a flap the way a finger would, along its length rather than at a point. They are small instruments, held between the thumb and fingers, for the fine edges of facial surgery: the skin of the nose, the eyelid and the edge of a scalp flap. Ours are the plain steel pair, in 10 and 12 mm.
Google AI Mode, read on 3 November 2026, calls saddle hooklets, which it also calls saddle hooks or lid retractors, specialized hand held instruments for soft tissue retraction. It says the saddle gives a broad, flat grip along tissue edges and spreads the pressure, which avoids the puncturing and tearing a sharp skin hook can cause. It describes fluted, flat or serrated handles; ours is flat and ridged.
Gemini, read the same day, gives saddle skin hooks and mini saddle retractors as catalog names, and places them in craniofacial, plastic and reconstructive and facial trauma surgery, on the skin of the nose, flaps round the eye and the edges of scalp flaps. A buyer looking for one saddle hooklet or a saddle skin hook is looking for this instrument.
Key design features
A saddle at the tip
In our photograph the tip is a short saddle, curved with a hollow in the middle, set at an angle to the shaft. The drawing beside it shows the saddle from the end. The hollow sits over the edge of the flap, and the pull is shared across the whole width. With no point to enter the skin, the hooklet can be moved along the edge and set down again without puncturing the skin.
Ten or twelve millimeters
The listing carries a 10 and a 12 mm saddle, both at 14 dollars. The 10 mm suits the eyelid and a short edge at the nose; the 12 mm holds a slightly longer edge. A pair of the same width, one in each hand of the assistant, holds a small flap open from both sides.
A ridged flat handle
The handle is flat and ridged along its length in our photograph. The ridges give the fingertips a grip that does not slip when the glove is wet, and the flat shape keeps the hooklet from rolling on the drape. It is held like a pencil, close to the tip, so the pull comes from the fingers and can be eased off the moment the skin blanches.
Plain steel
These are bright steel. Our Tessier saddle retractor is the same idea in black, with a slim round handle and three larger widths, for a field where glare from the lamp matters. Plain steel is the simpler choice for a tray that is cleaned with the rest of the steel instruments, with no coating to look after.
Which width to order
The saddle instruments on our site, read on 3 November 2026.
| What you get | Width | Finish | Price |
|---|---|---|---|
| Saddle hooklets, this page | 10 mm | Plain steel | 14 dollars |
| Saddle hooklets, this page | 12 mm | Plain steel | 14 dollars |
| Tessier saddle retractor | 10, 17.5 or 20 mm | Black | 14 dollars |
Where it is used
Gemini, read on 3 November 2026, places saddle hooklets in craniofacial, plastic and reconstructive and facial trauma surgery. The cases below follow the tissue it names.
| Case | What it holds | Width to start with |
|---|---|---|
| Eyelid surgery | The edge of the eyelid skin | 10 mm |
| Nasal surgery | The skin of the nose | 10 mm |
| Facial plastic surgery | A small flap round the eye | 12 mm |
| Scalp surgery | The edge of a scalp flap | 12 mm |
What it holds back, and what it must not do
They hold the edge of a flap. They do not hold a deep flap off the bone, and they are not levers.
| Job | Use the saddle hooklets? | What to use instead or beside it |
|---|---|---|
| Holding a thin flap edge without a point | Yes | This is the job they are made for |
| A wider saddle, in black | Beside it | The Tessier saddle retractor, up to 20 mm |
| Holding a flap off the facial bones | No | A double ended Tessier soft tissue retractor |
| Holding the orbital contents back | No | The Tessier orbital retractor, malleable |
| Levering bone | Never | An elevator; the saddle bends under that load |
How they compare with the rest of the family
Eleven Tessier, Hargis, Dingman and Seldin instruments make up this family on our site. The working ends are read off each listing’s own photograph, the options off the variations, the lengths off the name and the prices off the order form, on 3 November 2026.
| Retractor | Working end, from our photograph | Options on the listing | Length | Price |
|---|---|---|---|---|
| Tessier 12.5 cm black chromed | S shaped black band, a curved end at each side | one size | 12.5 cm | 18 dollars |
| Tessier 12 cm black | S shaped black band, a curved end at each side | five tip widths, 7 to 12 mm | 12 cm | 18 dollars |
| Tessier 15 cm | flat bar with a right angled blade at each end | one size | 15 cm | 18 dollars |
| Tessier 15.5 cm | flat bar with a right angled blade at each end | four blade pairs, or the set of four | 15.5 cm | 16 dollars, set 60 |
| Tessier 16 cm | flat bar with a right angled blade at each end | three blade pairs, or the set of three | 16 cm | 16 dollars, set 48 |
| Tessier orbital, malleable | flat strip with rounded ends, bent by hand | 10 to 12, 15 to 17 or 20 to 22 mm, or the set | not given on the listing | 11 to 32 dollars, set 56 |
| Tessier saddle, black | saddle shaped tip on a black round handle | 10, 17.5 or 20 mm | not given on the listing | 14 dollars |
| Saddle hooklets (this page) | saddle shaped tip on a ridged flat handle | 10 or 12 mm | not given on the listing | 14 dollars |
| Hargis 18 cm | deep curved blade with a turned tip, open handle | one size | 18 cm | 28 dollars |
| Dingman bone hook 19 cm | sharp hook on a slim shaft, open handle | Fig 1 or Fig 2 hook | 19 cm | 24 dollars |
| Seldin 19 cm | flat, gently curved blade on a flat handle | one size | 19 cm | 25 dollars |
Materials and finish
Every saddle hooklet we make is formed from high quality medical grade stainless steel. The steel itself is made to a German specification. We do not publish a grade number.
The finish is plain steel. The saddle width is part of the variation you order, so mark each one on the tray if you keep both.
Caring for it
Rinse them as soon as the case ends, before blood dries in the hollow of the saddle or in the ridges of the handle. Brush the saddle and the ridges, dry them, and steam sterilize them on the normal instrument cycle. Look at the saddle before it goes back on the tray, and set aside one whose edges have been bent.
Ordering and wholesale
The saddle hooklet is made by Adas Instruments in our own workshop and sold direct, which is why the price sits where it does against the catalog houses. Order one for a single tray, or in quantity for a hospital list or a distributor line. We do OEM work under your own brand and your own item numbers. Send us a sample and we will hold a run to your pattern rather than ours. Stock items ship from our own workshop. Backorder items take 10 to 12 working days to make. Every instrument carries a three year replacement warranty against manufacturing defects. Production is controlled under an ISO 13485 quality management system.
Frequently asked questions
What are saddle hooklets used for?
Saddle hooklets hold the edge of a skin flap with a broad saddle instead of a sharp point, in craniofacial, plastic and facial trauma surgery. AI Mode says the saddle spreads the pressure and avoids the puncturing and tearing a sharp skin hook can cause. Ours are 10 and 12 mm.
Are saddle hooks the same as saddle hooklets?
Yes. AI Mode gives saddle hooks and lid retractors as other names in its first sentence, and Gemini adds the saddle skin hook and the mini saddle retractor. All of them describe a small instrument with a saddle shaped tip.
Should I order the 10 mm or the 12 mm saddle hooklet?
The 10 mm suits the eyelid and a short edge at the nose. The 12 mm holds a slightly longer edge, such as a flap round the eye or a scalp flap. Both are 14 dollars, and a pair of each covers the small cases on a facial list.
How are these different from the Tessier saddle retractor?
The saddle works the same way. These are plain steel with a ridged flat handle in 10 and 12 mm. The Tessier saddle retractor is black, with a slim round handle, in 10, 17.5 and 20 mm, also at 14 dollars.
Can they be autoclaved?
Yes. They are stainless steel with no joint, screw or coating, and they go through the normal steam cycle with the rest of the tray. Brush the saddle and the ridged handle first, and dry them before they are packed.
Related products and categories
Three more instruments from the same family: the Hargis mandibular body retractor, the Dingman zygomatic bone hook and the Seldin periosteal retractor. The rest of the range is under maxillofacial instruments, which sits inside our ENT instruments.







Reviews
There are no reviews yet.